![]() ![]() Not really a cutlist, but I'll probably use it. When I input the job parts, I enter primary material for material name. With Fusion, I just might actually put that mouse to use again: modeling that walnut dining room table with butterfly leaves that I'm about to start I did a little bit of research, and while I didn't find a cutlist equivalent for Fusion, it looks like there is an extension that will provide a bill of material in CSV format that will list out everything in the model, along with length, width and height of each component. In the optimization setting,s I check use off-cuts first, even if cost is higher. But it was difficult enough to create an accurate model in Sketchup, that I mostly stopped using Sketchup and the mouse. Enough so that I even purchased a 3d mouse. I have a friend who told me how much he likes it, but I never really looked any further. ![]() We encourage you to run as many copies as you want and to tell your friends about it. I don't yet see how it is free for non-commercial use, but it's powerful enough that even if I have to buy a subscription, I might. MaxCut is the free board optimizer.MaxCut is leader in board optimization technology and uses advanced computer software to produce optimal cutting plans.MaxCut v2 is absolutely free to use. But Fusion takes 3d modeling to a whole new level. And I kept using it after Google set them free. I've been using Sketchup since just after Google bought them. I just downloaded Fusion, and I absolutely love it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |